<p><?=sprintf(__("To begin, ensure you have already filled in the form on the left with the date, station call, and operator's call. The main data includes the band (or QRG in MHz, e.g., %s), mode, and time. After the time, you provide the first QSO, which is essentially the callsign."),"'7.145'")?></p>
<p><?=__("If you don't provide any RST information, the syntax will use 59 for phone, 599 for CW and +0 dB for digital data modes. Our next QSO wasn't 59 on both sides, so we provide the information with the sent RST first. It was 2 minutes later than the first QSO.")?></p>
<p><?=__("The first QSO was at 21:34, and the second one 2 minutes later at 21:36. We write down 6 because this is the only data that changed here. The information about band and mode didn't change, so this data is omitted.")?></p>
<p><?=__("For our next QSO at 21:40 on 14th May, 2021, we changed the band to 40m but still on SSB. If no RST information is given, the syntax will use 59 for every new QSO. Therefore we can add another QSO which took place at the exact same time two days later. The date must be in format YYYY-MM-DD.")?></p>
<p><?=sprintf(__("Received exchange has to be prefixed with a dot %s, sent exchange with a comma %s. The last two lines are equivalent - i.e. spaces don't matter as the order doesn't as well. Each of the four lines above simply illustrates one type of exchange (serial only, text only, or both); note that the sent exchange is 'sticky': once set, it is automatically carried into the following QSOs (whenever the next line contains a received exchange or a single comma %s) until you change or wipe it. To automatically increment the sent serial, add %s to a QSO line together with an initial sent exchange (it does not work on its own line). To deactivate, use %s:"),"'.'","','","','","',++'","',+0'")?></p>
<p><?=sprintf(__("Here, the first qso uses the set serial 1, and the second will use 2 as the serial. If you want to wipe your sent exchange, use %s:"),"',-'")?></p>
<p><?=sprintf(__("First, all previous exchange is wiped, then only a serial is set. Otherwise the previous exchange %s would have been set also."),"'D23'")?></p>
<p><?=sprintf(__("If you log in local time instead of UTC, declare your offset once with %s (or the short form %s) followed by the signed hour offset. All following QSO times are then converted to UTC until you change the offset again:"),"'TIMEZONE'","'TZOFS'")?></p>
<p><?=sprintf(__("A full summary of all commands and the necessary syntax can be found in %sthis article%s of our Wiki."),'<a href="https://docs.wavelog.org/user-guide/logbook/simple-fle/" target="_blank">','</a>');?></p>
